Flaps
 |
 |
| Laid out The flaps | Used the cut off wheel to start the cuts on the ends. Then used the snips |
 |
 |
| Laid out, drilled and clecoed the bearings | Laid out hinges and drilled |
 |
 |
| Located the hinges with a simple wood jig. It kept it 3mm below the surface | Hinges Drilled and clecoed |
 |
 |
| Took a look at the revisions on the flaps and saw that the rotated the bearing 90 deg and made it a slot. This ought to make installation with the flap drive easier to line up. |
All assembled, and another view of the flap. I considered a doubler for
the old holes but it really isn't necessary.
Lesson Learned. Check the revision before drilling! |
 |
 |
| Used a small 1/8th measuring cup to measure out the Variprime. Worked well. It took about 1/4 cup of each for both flaps | I also used stamps to mark the ribs. It tried other methods but this worked well |
|
|
|
Home Page