The Elevator
 |
 |
| Laying out the cut | |
 |
 |
 |
 |
|
Paper template to make sure it is symmetric
|
|
 |
 |
| Using the cut off wheel to make the first cut | Started out with the snip on the left. Wasn't happy. Went to Lowes and bought a set of the offset ones on the right. Much better |
 |
 |
|
This is the angle Drill I bought from
Really works well |
The Trim tab |
 |
 |
| Cut out for the survo | |
 |
 |
| Got it all together and used a 9V battery to give it a try. Worked fine | |
 |
 |
| Marked with tape and cleaned it up with a belt sander. | The angle drill came in handy |
 |
 |
| A close up of the spacing. | All deburred and cleaned and ready to prime |
 |
 |
| Used Variprime (self etching) this time and a HPLV touch up gun. Worked great. A lot easier than the etching, alodine and the spray can. | |
 |
 |
| All done and stored away | |
|
|
|
Home Page