Ailerons
| These Ailerons are the ones with hinges. I was a little concerned about the stiffness of the normal hinges that ZAC uses so I went with the hinge option. |
|
|
|
Measured and cut the tips
|
 |
|
The geometry took a lot of study. The measurements are different
than the hingless option. Make sure you follow the plans
|
 |
|
Last cut
|
 |
|
Woops. Well it was going too easy. The tips do not quite meet
up.
|
 |
|
After a lot of pondering. I decided to cut the forward part and make
the end cap a two piece
|
 |
|
It doesn't look too bad
|
 |
|
The inboard side
|
 |
|
Another view of my modified tip
|
 |
|
I also went with the aileron trim option.
|
 |
|
A lot like the Elevator trim
|
 |
|
Installed from the top
|
 |
|
and the bottom
|
 |
|
Control horn
|
 |
|
All ready to prime
|
 |
|
Assembled and running the tab down
|
 |
| and up. All done
|
|
|
Home Page